# Autoleveling and CNC journey

**URL:** <https://forum.snapmaker.com/t/autoleveling-and-cnc-journey/5927>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [April 10, 2020, 12:28am UTC](https://forum.snapmaker.com/t/autoleveling-and-cnc-journey/5927 "2020-04-10T00:28:05Z")\
**Posts on this page:** 1\
**Showing post:** 16

<div class="post-metadata">

**Author:** ![Waldo](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/waldo/32/1704_2.png) [@Waldo](https://forum.snapmaker.com/u/Waldo)\
**Post date:** [May 21, 2020, 9:13pm UTC](https://forum.snapmaker.com/t/autoleveling-and-cnc-journey/5927/16 "2020-05-21T21:13:33Z")

</div>

Thank you @JKC20 . I’ve tested my suggestion and am happy to tell you that it works. Following is my process explained;

> [@Bed leveling for pcb milling?](https://forum.snapmaker.com/t/bed-leveling-for-pcb-milling/4579/28):
>
> @Mika, @Melanchrom, @Tone, @Edwin, @parachvte I’m pleased to announce that I have successfully leveled my Carving platform/Wasteboard. Can you please implement Manual Bed leveling for CNC in the next firmware? First, my CNC bed was 0.65mm lower at the back than the front, actually lower than the middle since the front and middle had the same offsets/measurements. I could not do a proper CNC engraving on acrylic. (same problem as milling on a PCB board) Following is my process; I followed …

---

_[View the full topic](https://forum.snapmaker.com/t/autoleveling-and-cnc-journey/5927)._