# 3d print rough and un-uniform

**URL:** <https://forum.snapmaker.com/t/3d-print-rough-and-un-uniform/10802>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [October 24, 2020, 2:54am UTC](https://forum.snapmaker.com/t/3d-print-rough-and-un-uniform/10802 "2020-10-24T02:54:31Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Atom](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/atom/32/5608_2.png) [@Atom](https://forum.snapmaker.com/u/Atom)\
**Post date:** [October 24, 2020, 3:01am UTC](https://forum.snapmaker.com/t/3d-print-rough-and-un-uniform/10802/2 "2020-10-24T03:01:13Z")

</div>

your to close to the print bed and you are under extruding as well (unless you have already calibrated your E steps) see the threads below for more info.

[Extruder Calibration a must](https://forum.snapmaker.com/t/extruder-calibration-a-must/7724)

[3D prints stick WAY too well!](https://forum.snapmaker.com/t/3d-prints-stick-way-too-well/9546)

---

_[View the full topic](https://forum.snapmaker.com/t/3d-print-rough-and-un-uniform/10802)._