10 Watt Laser Camera and Auto mode only in WiFi

Snapmaker 2.0
1

Just started using the 10 Watt laser upgrade today, and for some reason, I am only getting background camera capture and auto mode when using WiFi. Serial communication has neither of these functions for me.

Is this a known issue (sad that I need to ask I suppose), or is this something on my end? Calibration etc. all seemed to go off without a hitch (other than needing to adjust the calibration image).

1 Like
2

This is normal—the camera image is transmitted via Bluetooth rather than over the wire, so it bypasses the controller (or at least this is how it works with the original laser module, and I doubt it’s changed for the 10W).

2 Likes