Hardware


Heated Bed If the heated bed is causing problem to your printer, please report it here. For example, the heated bed is hot to the touch, but it shows NA on the touch screen. I made sure all the cables are properly and securely connected to the controller, but the problem persists.
Laser Engraving Module If the Laser Engraving Module is causing problem to your printer, please report it here.
Touch Screen If you have any questions about the touch screen, please post it here. For example, the touch screen is black when the power is on; the 3D printing module can react to the operations on the touch screen.
Power Adapter If you have any questions about the power adapter, please post it here.
CNC Carving Module If you have any questions about the CNC Carving Module, please post it here.
3D Printing Module If the 3D Printing Module is causing problem to your printer, please report it here. For example, the new filament can’t be inserted in to the hole. I pulled out the previous filament without heating the filament.
Controller If the controller is causing problem to your printer, please report it here. For example, the 3D Printing Module cannot move when the Z axis is connected to port 5 while the 3D Printing Module can move smoothly when the Z axis is connected to port 4. That means there is something wrong with port 5 on the controller.

About the Hardware category [Hardware] (1)
Touch works erratically [Touch Screen] (2)
Snapmaker Tower Tips! (Images included) [3D Printing Module] (1)
Optimal Layer Heights? full-step length? [3D Printing Module] (1)
Not impressed with the enclosure - holes don't line up [Hardware] (2)
Useful PETG guide [3D Printing Module] (20)
Power requirements [Hardware] (14)
The specification of the NEW LASER ENGRAVER (1.6W) [Laser Engraving Module] (11)
Retraction limits [3D Printing Module] (1)
Recommendation for noise [3D Printing Module] (4)
Filament Doesn't stick [3D Printing Module] (16)
Adding an extra fan? [3D Printing Module] (7)
Corner bracket are really not stable enough [Hardware] (5)
Assembly Equipment of worst quality and wrong screws/foots [Hardware] (8)
3D prints are turning out badly [3D Printing Module] (15)
CNC Platform Dimensions [CNC Carving Module] (1)
Layer Shifting problems [3D Printing Module] (20)
Cooling Fan Facing downward? [3D Printing Module] (11)
Laser dead after two days of use [Laser Engraving Module] (7)
First engraving [Laser Engraving Module] (1)
Laser No Longer Burning [Laser Engraving Module] (11)
Feed rate problem? [3D Printing Module] (4)
Calibration detail? [3D Printing Module] (9)
Controller suggestions [Controller] (3)
Are the FANS Noisy? [Hardware] (7)
Micro SD vs USB-A [Hardware] (3)
Prints lifting up from bed [Hardware] (16)
When the filament sticks too good [Heated Bed] (7)
Controller Fan noise [Controller] (11)
Printhead pinouts [3D Printing Module] (2)