Heated Bed will not go upto 90, ABS print fails

[jhy]

I know. There has been a thread about this change

Why only 80 degrees?

Hello. I had my first attempt at printing ABS. Needless to say, I ran into problems, but it also pointed out one important issue to me. We were promised that the bed would go from 20 degrees to 100 degrees, as noted on the campaign page: https://www.kickstarter.com/projects/snapmaker/snapmaker-the-all-metal-3d-printer/description – under the “Specification” heading. So why are we only getting 80 degrees? My readings on ABS state that we should be printing anywhere between 100 and 120 degre…

And I guess there isn’t much we can do, unless you want to modify the hardware.
For example, improve thermal insulation, add secondary heating method, or do something with the heat bed directly