I installed the new door switch on my unit. I installed the latest firmware 2.8. I started a print. Then when I closed the door the print head went off the printing plate. I disconnected the door switch wire to the controller and the print then worked with the door open or closed. I didn’t real…

Door Switch causes problem

steve_snapmaker April 3, 2019, 2:59am 3

@ljlaursen I think you can find the answer at Printer crashes on operating enclosure micro-switch. Please don’t hesitate to tell us if you have any problem. Thanks

Topic		Replies	Views
Cannot print with enclosure door closed Snapmaker Original	4	1230	January 19, 2022
Trouble printing with enclosure v1.1 Snapmaker Original	17	1495	October 29, 2022
Not able to activate the door detection Snapmaker Original	8	1103	December 8, 2020
Intermittent loss of enclosure control during prints Snapmaker 2.0	4	250	July 29, 2021
Laser head moving but not lasering Snapmaker 2.0	2	511	February 14, 2021